1、傳動裝置的維護與保養。使用前應加潤滑油，潤滑油牌號為LKC100，150#中負荷極壓工業齒輪油。
1. Maintenance of transmission device. Before use, add lubricating oil with the brand of LKC100150 # medium load extreme pressure industrial gear oil.
2、滾簡軸承的潤滑。滾簡軸承為UCP系列(常用UCP214)，用潤滑脂潤滑，每天加油一次。
2. Lubrication of plain roller bearing. The simple roller bearing is a UCP series (commonly used UCP214), which is lubricated with grease and refueled once a day.
3、滾簡與托輥的清理。自上料水泥攪拌車，經常清理滾簡和托輥上的積料，積料過多會影響皮帶的運行，出現跑偏的情況。自上料水泥攪拌車
3. Cleaning of roller and idler. The self-feeding cement mixer truck often cleans up the accumulated material on the roller and idler. Excessive accumulated material will affect the operation of the belt and cause deviation. Self-loading cement mixer
4、刮砂裝置的維護。定期檢查刮砂裝置的磨損程度，刮砂裝置磨損到一定程度后及時更換。
4. Maintenance of sand scraping device. Regularly check the abrasion degree of the sand scraping device, and replace the sand scraping device in time after it is worn to a certain extent.
5、自上料水泥攪拌車，橡皮擋邊的更換。橡皮擋邊磨損嚴重，有料撒出時應及時更換。
5. Self-feeding cement mixer truck, rubber baffle replacement. The rubber edge is seriously worn, and it should be replaced in time when there is material scattered.
6、接口斷裂及橫向撕裂的防范及處理。接頭硫化處理不合格; 沖擊負載過大，薄弱部分受交變應力影響斷裂;接口方向與皮帶運動方向不合適；長期使用等，嚴重損壞皮帶。自上料水泥攪拌車，在使用時要盡量減少負載，特別是有配重張緊裝置的皮帶，應控制配重在200kg~300kg內，以雨季不打滑為宜，加強巡查，防止異物卡死皮帶，劃傷皮帶;加強對皮帶裝配人員的培訓，防止皮帶接口方向裝反。
6. Prevention and treatment of interface fracture and transverse tear. The joint vulcanization treatment is unqualified; The impact load is too large, and the weak part breaks under the influence of alternating stress; The interface direction is not suitable for the belt movement direction; If it is used for a long time, the belt will be seriously damaged. When using the self-feeding cement mixer truck, the load shall be reduced as much as possible, especially for the belt with counterweight tensioning device, the counterweight shall be controlled within 200kg~300kg, and it is advisable not to slip in the rainy season, and the patrol inspection shall be strengthened to prevent foreign matters from blocking the belt and scratching the belt; Strengthen the training of belt assembly personnel to prevent the belt interface from being reversed.
